PHILIPS单片1632位微控制器－LPC2210------外文文献翻译.doc

外文文献 LPC2210 16/32-bit ARM microcontroller; with 10-bit ADC and external memory interface Rev. 01 — 09 February 2004 Preliminary data 1. General description The LPC2210 is based on a 16/32 bit ARM7TDMI-S? CPU with real-time emulationand embedded trace support. For critical code size applications, the alternative 16-bitThumb Mode reduces code by more than 30% with minimal performance penalty. With its 144 pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, PWM channels and up to 9 external interrupt pins this microcontroller is particularly suitable for industrial control, medical systems, access control and point-of-sale. LPC2210 provides up to 76 GPIO depending on bus configuration. Witha wide range of serial communications interfaces, it is also very well suited forcommunication gateways, protocol converters and embedded soft modems as well as many other general-purpose applications. 2. Features 2.1 Key features ? 16/32-bit ARM7TDMI-S microcontroller in a LQFP144 package. ? 16 kB on-chip Static RAM. ? Serial boot-loader using UART0 provides in-system download and programming capabilities. ? EmbeddedICE-RT and Embedded Trace interfaces offer real-time debugging with the on-chip RealMonitor software as well as high speed real-time tracing of instruction execution. ? Eight channel 10-bit A/D converter with conversion time as low as 2.44 ms. ? Two 32-bit timers (with 4 capture and 4 compare channels), PWM unit (6 outputs), Real Time Clock and Watchdog. ? Multiple serial interfaces including two UARTs (16C550), Fast I2C (400 kbits/s) and two SPIs?. ? Vectored Interrupt Controller with configurable priorities and vector addresses. ? Configurable external memory interface with up to four banks, each up to 16 Mb and 8/16/32 bit data width. ? Up to 76 general purpose I/O pins (5 V tolerant). Up to 9 edge or level sensitive external interrupt pins available. ? 60 MHz maximum CPU clock available from programmable on-chip Phase-Locked