推挽式功率放大电路的设计课程设计.docVIP

推挽式功率放大电路的设计 第 一 部 分 课 程 设 计摘 要 桥式推挽NE5532将小信号电压放大，使其能够驱动功率放大器；功率放大电路由倒相电路和BTL电路两部分组成，从而提高输出功率V直流电压。Protel软件对所设计的电路图进行建库、绘图、制板；再借助Multisim仿真软件对各个单元电路进行仿真，，达到了设计的目的Abstract The push-pull circuit occupies an important position in the amplifier circuit and switching power supply areas. Bridge push-pull amplifier circuit is constituted by three parts of the power supply circuit, the preamplifier circuit, BTL power amplifier circuit. The preamplifier circuit uses the integrated operational amplifier NE5532 small signal voltage amplification, so that the power amplifier input sensitivity to match. The power amplifier circuit consists of two parts of the inverting circuit and BTL circuit. The former is responsible for the conversion for the latter two of equal size, in the opposite direction of the excitation signal. The latter is the signal undistorted under the premise, as far as possible to enlarge the current, increasing the output power. ± 12V DC voltage power circuit through the buck, rectifier, filter and regulator.With of Multisim simulation software on each unit circuit performance and functional simulation. Verify the correctness of the design through simulation analysis, the results are to achieve the intended purpose of the design. Then use Protel software for building a database, drawing and board schematic design. Keywords：ush-pull amplifier, Integrated operational amplifier, Preamplifier , Inverting 目 录 摘 要 I Abstract II 第一章 推挽式功率放大器方案设计 1 1.1 绪论 1 1.2 功率放大器的性能指标 1 1.3 推挽式功率放大器设计方案 2 1.3.1 变压器耦合式推挽功放 2 1.3.2 桥式推挽功放 2 1.3.3 方案分析 3 第二章 推挽式功放电路设计 4 2.1 前置放大电路 4 2.1.1 反相比例放大电路 4 2.1.2 同相比例放大电路 5 2.1.3 前置放大电路 5 2.2 BTL功放输出电路 6 2.2.1 倒相电路 6 2.2.2 BTL电路 7 2.3 电源电路 7 2.4 整体电路 8 第三章 推挽式功放电路仿真与实验 10 3.1 前置放大电路仿真 10 3.2 倒相电路仿真 11 3.2 整体电路仿真 11 总 结 13 参考文献 14 致 谢 15 附录1 推挽式功放电路图 16 附录2 推挽式功放元件明细表 17 第一章 推挽式功率放大器方案设计 在音响世界中往往需要将低频信号放大后加以利用，一般处理频率较低的信号采用音频功率放大电路来实现。它的作用是对音频信号进行不失真的功率放大，以足够的电功率去推动扬声器，故而音频功率放大电路在音响产品中得到广泛使用。 1.1 绪论 功放级输