ANSYS12.0_workbench教程.pptVIP

. . . Working With Units Create custom unit systems by duplicating existing systems then modifying. Custom unit systems can be exported and imported. H. License Preferences Workbench license control is handled through the user interface shown below, activated from the Workbench project page (“Tools License Preferences . . . “). . . . License Preferences With the available licenses displayed, the activation and “use order” can be specified using the up/down arrows. 0 = off, 1 = on License order represents the preference order for license use. The license control allows Workbench users to specify whether a single license is used when multiple applications are open, or if all open applications access their own license. . . . License Preferences In the example shown, a user could have 3 Mechanical models open simultaneously. Using the license control they may choose to open 3 licenses or use only 1 that is shared. In the shared scenario, only the active Mechanical session uses the license (the remaining will be read only). Introduction 1-* ANSYS, Inc. Proprietary ? 2009 ANSYS, Inc. All rights reserved. February 23, 2009 Inventory #002593 Training Manual 1-* ANSYS, Inc. Proprietary ? 2009 ANSYS, Inc. All rights reserved. February 23, 2009 Inventory #002593 Workbench - Mechanical Introduction 12.0 Chapter 1Introduction Welcome! Welcome to the ANSYS Mechanical application introductory training course! This training course covers the basics of using ANSYS Mechanical in performing structural and thermal analyses. It is intended for all new or occasional ANSYS Mechanical users, regardless of the CAD software used. Course Objectives: General understanding of the user interface, as related to geometry import, meshing, application of loads and supports, and postprocessing Procedure for performing FEA simulations, including linear static, modal, and harmonic structural analyses and nonlinear steady-state thermal analyses Utilizing parameters for ‘what-if’ scenarios Interfa