31RM45.板坯感应加热有限元分析-RAL梅瑞斌.pdfVIP

2007 年全国塑性加工理论与新技术学术研讨会 2007 年5 月 沈阳 板坯感应加热有限元分析* 1 1 2 1 梅瑞斌 , 李长生 , 韩 斌 , 刘相华 (1.东北大学轧制技术及连轧自动化国家重点实验室，沈阳 110004 2.武汉钢铁集团公司，武汉 430081) 摘 要：本文利用有限元法分析分析了不同工作频率下的热轧板坯高温感应加热过程，结果表明：工作频率较低时， “集肤效应”不十分明显，涡流透入深度与工作频率满足δ ∝1 f 关系；工作频率和形状尺寸对感应加热过程有重要影 响，工作频率较低时，温度最大点位于上表面距对称轴一定距离处。随着工作频率增加，温度最大值向板坯角部移 动。矩形板坯感应加热过程较为复杂，应该根据不同工艺要求选择合适的工作频率。计算了某板坯的感应加热过程， 并将计算结果和实测值进行了比较分析，结果吻合良好。分析结果为热轧板坯高温感应补偿加热生产实践提供依据。 关键词：有限元；热轧；感应加热；电流密度；温度分布 Fem Analysis of Slab Steel Temperature During Induction Heating 1 2 1 MEI Reibin , LI Changsheng, HAN Bin , LIU Xianghua 1 State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China, 2 Wuhan Iron and Steel Group Corporation, Wuhan, 430081, China, Abstract: High temperature induction heating process analysis of hot rolling billet by finite element method with different frequency had been carried out in the paper. The results show that skin effect is not apparent with low-frequency and the relation between eddy penetration and frequency is. Both frequency and billet shape have important influence on induction heating process and the max temperature point lies δ ∝1 f in top surface and is apart from symmetry axis. The max temperature moving to corner with the increase of frequency and it should be selected proper frequency for different induction heating process. In addition to these, the induction heating process was simulated according to the technology requirements provided by a steel