55冷轧及退火工艺对（Ti＋Nb）－IF钢组织性能的影响－北科周欢.pdfVIP

2007 年全国塑性加工理论与新技术学术研讨会 2007 年5 月 沈阳 冷轧及退火工艺对（Ti ＋Nb ）－IF 钢组织性能的影响 1,2 1 1 1 周 欢 ，赵爱民 ，陈银莉 ，滕 涛 （1.北京科技大学冶金工程研究院，北京 100083；2.宝钢特殊钢分公司，上海 200940 ） 摘 要：研究了冷轧总压下率、退火温度及保温时间对（Ti ＋Nb ）－IF 钢组织和性能的影响。结果表明：当冷轧总 压下率达到 75 ％时，高温退火后r 值就达到 1.80 以上，并随压下率的增大而上升，到 85 ％时，r 值达到最大值 2.10 左右，当冷轧总压下率达到 90 ％时，r 值开始下降。超低碳（Ti ＋Nb ）－IF 钢热轧板经 80 ％压下率冷轧后，退火温 度低于 850℃时，r 值随退火温度的上升而上升，850℃以上退火时，r 值受退火温度影响不明显，r 值保持在 1.95 左 右。在 850℃以上高温退火条件下，保温时间在 60s～120s 之间时，r 值受保温时间影响很小。 关键词：（Ti ＋Nb ）－IF 钢；冷轧；退火；r 值 The Effects of Cold Rolling and Annealing Technology on Microstructure and Properties of （Ti + Nb ）-IF Steel 1,2 1 1 1 ZHOU Huan ，ZHAO Aimin ，CHEN Yinli ，TENG Tao ( 1. Research Institute of Metallurgy Engineering,University of Science and Technology Beijing, Beijing 100083, China;2.Baoshan Iron Steel Co. Ltd. Special Steel Branch, Shanghai 200940) Abstract: The effects of cold rolling reduction, annealing temperature and holding time on microstructure and properties of (Ti+Nb)-IF Steel was studied. The results show that, when total cold rolling reduction reaches 75 ％, r value can reach above 1.80 after annealing at high temperature and increases with the cold rolling reduction growth, until 85 ％, r value reaches about 2.10, then r value begins to decrease when total cold rolling reduction reaches 90 ％. After (Ti+Nb)-IF steel hot rolling sheets cold rolled by 80 ％ reduction, when annealing temperature below 850 ℃, r value increases with annealing temperature growth. The effects of annealing temperature on r value is not marked when annealing temperature above 850 ℃, then r value maintains about 1.95. Under the condition of annealing temperature above 850 ℃, when holding time is b