大学综合行政办公楼建筑结构设计计算书(毕业论文).doc

东营石油大学综合行政办公楼建筑结构设计 摘 要 本毕业设计题目为“东营石油大学综合行政办公楼建筑结构设计”。设计的内容包括建筑设计、结构设计两部分。建筑设计是在总体规划的前提下，根据设计任务书的要求，查阅办公楼设计规范，确定设计方案，画出建筑施工图。结构设计是在建筑物初步设计的基础上确定结构方案并绘制结构施工图。 本设计采用钢筋混凝土现浇框 架结构，建筑面积为8748.54㎡，建筑层数为上部六层（层高均为3.6m），地下一层(层高4.2m)，建筑高度为21.6m。根据设计要求，设防烈度为7度，抗震等级为3级，设计中不考虑风荷载作用。本方案主体结构为纵横向承重框架。在进行荷载计算和构件截面估算后，选取了一榀框架进行计算，计算内容包括：恒载、活载、地震作用下框架梁端和柱端弯矩、剪力及轴力的计算；框架梁内力调幅；框架梁、柱内力组合；框架梁、柱配筋计算；楼梯配筋计算；板配筋计算；筏板基础配筋计算。 整个结构设计过程中，严格遵循相关的专业规范的要求，参考相关资料和有关最新的国家标准规范，对设计个各个环节进行综合全面的科学性考虑。总之安全、适用、经济是本设计的基本原则。 关键词：办公楼，建筑设计，结构设计，框架结构，荷载计算，配筋计算 DESIGN OF BUILDING STUCTURE OF THE ADMINISTRATIVE OFFICE OF DONGYING PETROLEUM UNIVERSITY ABSTRACT The topic of graduation project has been shown as the title, and this project includes design of architectural design and structural design. According to the assignment book, the architectural design is to plot the construction drawing of the objective building under the specification for the office design. And based on the architectural design, the structural design is to plot the structural construction drawing with the corresponding structural calculation. The objective of this project is framework construction of cast-in-place reinforced concrete. This building insist of overground with six floors (3.6m per floor) and underground parking lot (4.2m), and the total height of this building comes to 21.6m. According to the design requirement, fortification intensity comes to 7 and class of anti-seismic measure is 3, also this project didn抰 consider the wind load. The main structure in this project is bearing frame in both virtual and horizontal direction. After the calculation of loading and section, the author used single frame for calculation, and the content of calculation include the selection of section measurement of girder and column and the calculation of linear stiffness; the calculation of moment, shearing force and axial force at the end of girder and column; regulation of internal force of girder; arrangement of internal forc