基于ANSYS焊接方法对焊接应力影响研究.pdfVIP

年 月 金属铸锻焊技术 ting · ing · ding 2010 8 Cas Forg Wel 基于ANSYS 的焊接方法对焊接应力的影响研究 付建科， 雷小平， 卢泽民 （三峡大学机械与材料学院，湖北 宜昌443002 ） 摘 要：依据ANSYS 弹塑性有限元理论对四种不同焊接方法下对接平板的焊接过程进行了数值模拟，确定了堆 焊薄板焊后的残余应力和焊接变形分布，并对结果进行了分析比较。发现除直通焊外，其他三种焊接方法下焊后横向残 余应力都存在正负反复波动，这主要是由焊接过程中温度分布不同和焊缝及近缝区的横向收缩引起的。 研究方法和结 果对合理的选择焊接方法、控制和预测焊接残余应力和变形提供参考。 关键词： 数值模拟；焊接方法；残余应力；有限元 中图分类号： 文献标识码： 文章编号： TG404 A 1001-3814(2010) 15-0136-03 Study on Effect of Welding Methods on Welding Stress in Bead-welded Plane Based on ANSYS ， ， FU Jianke LEI Xiaoping LU Zemin (College of Mechanical Material Engineering, China Three Gorges University, Yichang 443002 ， China) 库 Abstract ： The numerical simulation of welding processes for bead-welded plane in four different welding method was 例 made according to ANSYS elastic-plasticity theory. The residual stresses and deformations after welding were acquired. It is found that the transversal residual stresses in other three sequences are waved except through welding, which are mainly 案 caused by the differences of temperature distribution and transversal shrinkages of weld seam. It provides an important E n reference for choosing welding method and protecting and controlling the welding residual stress and deformation. A c .