钢碗的有凸缘筒形件拉深模具设计论文.docxVIP

武汉生物工程学院毕业论文(设计)题目名称钢碗的有凸缘筒形件拉深模具设计题目类别毕业论文系别机电工程系专业班级0913410525学生姓名王雷指导教师吴芬/助教辅导教师吴芬/助教完成日期2013年4月30日摘要简短介绍了我国模具行业发展状况，以及在当下模具行业情况，并且对国内外模具行业发展现状加以分析，从而对我国模具行业与国外模具行业进行了综合比较提出差距所在。同时介绍了模具的类型和主要功能。综合阐述对镶套落料拉深模具进行设计，首先对工件进行工艺分析，对拉深特点拉深变形过程进行技术分析。在设计之前先确定修边余量和毛坯尺寸是否需要使用压边圈。其次对拉深模具进行总体设计，了解拉深模具结构、分类，选择压边装置。然后确定工作部分结构参数，确定拉深系数及工序尺寸。计算凸模圆角半径、凹模圆角半径、间隙、凸、凹模尺寸公差、压边力、压边圈尺寸、拉深力、卸料力、拍样计算，并计算压力中心对压力机进行选择。最后选择模具主要零部件及结构，对模具材料、模架进行选择，计算凸模长度、凹模高度和壁厚、凸模固定板尺寸以及校核凸、凹模强度。同时设计选择其他零部件，确定模具闭合高度，对拉深模具进行安装调试。关键词模具；冲压；凸模圆角半径；尺寸公差；间隙；拉深力；凸、凹模.AbstractA brief introduction to Chinas mold industry development, and in the mold industry, and the current situation of the development of mold industry are analyzed, which are compared to the gap in the mould industry in our country and foreign mould industry. At the same time introduced and main function mold type.A comprehensive set of insert falls design drawing die, first through the process analysis of the workpiece, analyzes characteristics of drawing deformation process of drawing. In the design before trimming allowance and blank size is required the use of blank holder. Secondly, the whole design of the drawing die, drawing die, understand the classification, selection of the edge pressing device. Then determine the structure parameters, determine the drawing coefficient and the process dimensions. Calculation of punch radius, die radius, the gap, convex, concave die size tolerance, BHF, the edge pressing ring size, drawing force, stripping force, shoot calculation, and calculation of the pressure center of press. The final choice of main parts of die and the structure, the choice of mold materials, mold, punch length calculation, die height and thickness, punch plate size and check the convex, concave die strength. At the same time, other parts design, determine the height of the closed mold, installation and commissioning of the drawing die.Key wordDies; stamping; punch radius; dimensional tolerances; clearance; drawing force; the convex,