非接触式高压检测电路设计(毕业论文).docVIP

（2011届） 本科毕业设计（论文）资料 题 目 名 称： 非接触式高压检测电路设计 学 院（部）： 电气与信息工程学院 专 业： 电子信息科学与技术 最终评定成绩： 摘 要 基于目前市场上常规的高压检测往往采用接触式的检测方法，因此本文设计了一个非接触式高压检测电路来进行高压检测。 该电路的主要检测方法为，用高压探头将高压设备附近的强电场，转换成一定幅度的小信号，送入信号调理电路进行调整和判断，当检测到的电压高于设定值时，输出信号使报警电路进行声光报警，本设计中还包含了一个电源转换电路，能够将外界电压转换为电路工作电压。本文所述电路能使检修人员采用非接触方法检测出设备是否存在高压，以保证操作者的人身安全，从而达到检测目的。 文中信号调理电路中，包含了一阶低通滤波电路、同相放大电路、比较电路、报警控制电路。 文中语音提示电路中包含语音芯片ISD4003、扬声器、放大电路。 文中电源转换电路包含了全波整流桥、整流器、电源模块。 关键词：信号调理电路，电源转换电路，语音提示电路，发光电路 ABSTRACT Based on the current market, the test of conventional high voltage often adopts the method of contact detection, so this thesis designed a non-contact high voltage detection circuit for the test of high voltage. The main testing method of this thesis is changing the strong electric field near the equipment of high voltage into a certain range of small signal by high voltage probe. And then it is sent to signal conditioning circuit for adjustment and judgment, output signal will carry out a sound and light alarm in an alarm circuit when the high voltage is detected higher than the setting value. This design also includes electric power conversion circuit which can change the external voltage into operating voltage in the circuit. The circuit which is described in this thesis can helps maintenance personnel to test whether the equipment has high voltage or not by the non-contact method, in this case, the safety of operators can be assured, thereby, we can achieve the goal of detection. Signal conditioning circuit in this thesis includes First-order low-pass filter, phase amplifier, comparator circuit, and alarm control circuit. Voice prompt circuit in this thesis includes Voice chip ISD4003, entire speaker, and amplifier circuit. Power conversion circuit in this thesis includes full-wave bridge rectifier, rectifier, and power module. Keywords: signal cond