印度BALCO扩建4x300 MW燃煤电站工程模拟量控制系统负荷变动试验调试方案.docVIP

TEST PROCEDURE OF LOAD FLUCTUATION TEST OF MODULATING CONTROL SYSTEM FOR BALCO EXPANSION PROJECT 4×300 MW THERMAL POWER PLANT 印度BALCO扩建 4×300 MW 燃煤电站工程 模拟量控制系统负荷变动试验调试方案 ITEM NO.: BALCO-COMM-IP009 Complied by: 编 写： Checked by: 初 审： Revised by: 审 核： Approved by: 批 准： 目 录 Contents 1. 编制目的 Compile Purpose 2. 负荷变动范围 Load change range 3. 调试前必须具备的条件 Conditions of commissioning 4. 调试步骤 Process of commissioning 5. 注意事项 Precautions 6. 附录 Append 编制目的 Compile Purpose 为了指导及规范系统及设备的调试工作，检查机组模拟量控制系统适应负荷变化的能力，制定本方案。 This procedure is compiled as a guide and standard for practices of tesing and adjustment to facilitate examination the ability of modulating control system (MCS) to track and meet fluctuating load demand. 负荷变动范围 Load change range 负荷稳定在65%-100% MCR之间时，通过协调控制以3% MCR/min负荷变化速率，变化负荷，持续时间最长为5分钟。 Keep the unit running steadily on load from 65% to 100% MCR, change the load through CCS at rate of 3% respectively, with each load level lasting for 5 minutes at most. 调试前必须具备的条件 Conditions of commissioning 3.1机组具备带满负荷、安全稳定运行的能力。 Unit should be capable of running on full-load stably and safely. 3.2协调控制系统各功能经试验已投入运行，主要模拟量控制系统如炉膛压力控制、锅炉风量控制、锅炉给水控制、主汽温度控制、再热蒸汽温度控制、燃烧控制已投入运行，调节品质优良。 All functions of CCS should have been tested and put into service. The following main features of MCS should have been running satisfactorily. Furnace pressure control Boiler air flow control Boiler feed water control Main steam temperature control Reheat steam temperature control Combustion control 3.3负荷在65%-100%MCR。 Unit load should be kept between 65% and 100%MCR. 调试步骤 Process of commissioning 4.1逐步投入以下各主要系统的自动调节回路： 主蒸汽压力调节系统 锅炉给水调节系统 主蒸汽温度调节系统 再热蒸汽温度调节系统 炉膛压力调节系统 送风及氧量校正调节系统 The following regulating loops of MCS should be put into operation in succession: Main steam pressure control system Boiler feed water control system Main steam temperature control system Reheat steam temperature control system Furnace pressure control system Boiler a