C620车床尾架套筒的工艺规程设计和铣8mm槽的夹具设计（含CAD图纸全套）.doc

买文档后送图纸，QQ 194535455 XX大学 毕业设计（论文） 题目 C620车床尾架套筒的工艺规程　 　 设计和铣8mm槽的夹具设计　　 学 号 学 生 指 导 教 师 起 止 日 期 摘 要 本次设计的主要内容是C620车床尾架套筒零件加工工艺规程和铣8mm键槽夹具设计。套筒零件是和尾架部分配合使用的，其主要加工面是外圆表面及莫氏四号孔。由加工工艺原则可知，保证外圆面的加工精度要比保证孔的加工精度容易。所以本设计遵循先面后孔的原则。并将孔与外圆面的加工明确划分成粗加工和精加工阶段以保证加工精度。整个加工过程选用通用机床。其中莫氏四号内孔及外面表面粗糙度要求较高，经过磨削后能达到粗糙度要求。铣削8mm键槽时，主要是以外圆面和套筒孔中心线做定位基准，采用V型块作为定位夹具，分析定位夹具的误差来源，对掌握保证和提高加工精度的方法非常重要。本文的研究重点在于通过对机床尾架套筒的工艺性和力学性能进行分析，对加工工艺进行合理安排，结合实践，最终完成C620机床尾架套筒的设计要求。 关键词: 套筒，加工工艺，铣槽，定位，夹具 Abstract The main content of this design is to design the tailstock sleeve parts processing procedures and milling 8mm keyway fixture C620 lathe. Sleeve parts and the tailstock part matched, the main processing surface is a cylindrical surface and Morse No. four holes. By the principle known processing, ensure the machining accuracy of cylindrical holes than guarantee the machining precision easy. So the design follows the principle of the surface after the first hole. And the processing hole and excircle surface clearly divided into roughing and finishing stages of processing to ensure accuracy. The entire process used universal machine tool. The Morse No. four bore and outside surface roughness higher, after grinding can reach roughness requirements. Keyway milling 8mm, mainly outside circular surface and the sleeve hole center line to do the locating datum, using V block as a positioning clamp, error source analysis positioning fixture, to guarantee and improve the machining precision of the method is very important. The focus of this paper is that through the analysis process and the mechanical properties of the tailstock sleeve, the processing technology for reasonable arrangement, combined with the practice, finally completed the design requirement of the C620 machine tool tailstock sleeve. Keywords: sleeve, machining, milling, positioning, clamping 目　录 摘　要................................................................2 引 言..................................................