不同温度下微波烧结Fe_Cu_C性能.pdfVIP

39 4 () Vol.39 No.4 2008 8 J. Cent. South Univ. (Science and Technology) Aug. 2008 Fe-Cu-C ( 410083) Fe-2Cu-0.6C 1 150 7.20 g/cm3413.90 MPaHRB75 Fe-Cu-C TF125.9 TG146.1 A 1672−7207(2008)04−0723−06 Properties of Fe-Cu-C alloys microwave sintered at different temperatures PENG Yuan-dong, YI Jian-hong, GUO Ying-li, LUO Shu-dong, LI Li-ya (State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China) Abstract Fe-2Cu-0.6C powder metallurgy material was researched on microwave sintering. The properties and microstructure of microwave sintered sample were studied at different sintering temperatures, and microwave sintered samples were compared with conventional sintered samples under the same conditions. The results show that compared with the conventional sintering, microwave sintering samples have higher sintering density, higher tensile strength, greater elongation and equal Rockwell hardness. The optimum performance is obtained for microwave sintered samples sintered at 1 150 for 10 min soaking, the sintered density is 7.20 g/cm3 which is the maximum density. The tensile strength is 413.90 MPa and hardness HRB is 75. Microwave sintered sample has finer microstructures, i.e., small, rounded and uniformly distributed pores, which is advantageous to obtain the tiny crystal grain and high density. There are more flaky