STATICANDDYNAMICANALYSISOFCONNECTINGROD…：连杆的静态和动态分析….pdfVIP

International Journal of Automobile Engineering Research Development (IJAuERD) ISSN 2277-4785 Vol. 3, Issue 3, Aug 2013, 23-30 © TJPRC Pvt. Ltd. STATIC AND DYNAMIC ANALYSIS OF CONNECTING ROD OF COMPRESSOR 1 2 SHRIRAM A. PHAD D. H. BURANDE 1Research Scholar, Sinhgad College of Engineering, Pune, Maharashtra, India 2Guide and Professor, Sinhgad College of Engineering, Pune, Maharashtra, India ABSTRACT The objective of study is performed on a cast iron connecting rod of a compressor for the static and dynamic analysis. Literature survey suggests cyclic loads comprised of static tensile and compressive loads are often used for design and analysis of connecting rods. The S-N approach by Modified Goodman criterion to fatigue life prediction of the connecting rods is presented. The possibility failure of the connecting rod approach by Failure Index is the ratio of Maximum Principal Stress to yield strength of material. The three-dimensional finite element model is constructed in PRO- E and used for Analysis. The model is meshed in ANSYS workbench and used for Analysis. KEYWORDS: Connecting Rod, FEA Analysis, Failure Index INTRODUCTION The function of connecting rod is to transmit the thrust of the crankshaft to piston by translating the rotational motion of crankshaft to the reciprocating motion of piston. Connecting rods are subjected to inertia force due to reciprocating mass and gas forces due to maximum gas pressure results in axial and bending stresses. Bending stresses originate due to eccentricities, crankshaft, case wall deformation, and rotational mass force. Therefore, a con