Citisteel 4060mm宽厚板轧机板形问题分析和改进措施_宽厚板_2000tr.pdfVIP

维普资讯 第6卷第4期 宽厚板 · 综述· o f4)卜} Citisteel 4060mm宽厚板轧机板形17题 的分析和改进措施 张进之 王 琦 而弱磊) 摘 要 通过对Citisteel三年板凸度数据的分析．认为采用合理的配辊制度和精心操作可提高板形质量， 通过增加轧辊原始凸度可降低平均板凸度，但不能改进板凸度的标准差，固此生产出来的钢板凸度披动较大。 分斩后认为采用动态设定板形测控方法的板形最佳规程，不但可以进一步葶晕低平均板凸度，而且可以大大降低 其标准差。通过与中国首钢和舞钢两套宽厚板轧机对比及参考它们的经验，Citisteel工作辊换辊周期应当减 小，轧4 O00t左右换一次工作辊比较台适。文中提出用动态设定量板凸度模型建立轧辊热凸度模型的新方法 关键词 厚板 至．呈堡 禽榀 砗船5 Analysis and Improvement Methods of Pl ate Profile Control for 4064mm Plate Mill at Citisteel in U．S．A ZhangJin。hiand Wan gQi 倚；jj 7／ (Beljing Central Iron and Steel Research Institute) 【 I． ／ 下 j；r_ ／ Abstract By analysis of crown data of 4--high plate m．】]ot Cifisteel in U S A·it is believed that appli6a— hie roll Crov~rl schedule and eare[ul operation can improve the plate profile quality，~urthermore．increasing the roll ci~c．wn call reduce the average plate crown·but it can not reduce the plate crovfTi standard deviation，thus the standard deviation ot plate crown ranges widely．By employing the profile optimized rolling schedule based on dynamic setting profile measuHng and control method，the average plate crown can be reduced as well as the standard deviation of the plate c 。wn．By comparison with wide plate mills of Capital Steel and Wuyang Steel the work roll change period should be reduce，the reasonable range is every 4 000 tons Also in this artl— c]e，the new method of the hot roll crown model was put~orward Keywords Heavy plate，P1ate crov~r1．Hot roll Crown mo