稳压电源中英文文献外文翻译.doc

山东理工大学 毕业设计 （外文翻译材料）   学 院：电气与电子工程学院 专 业：09电气双学位 学生姓名：张晓丽 指导老师：孙 凯 NC switching power supply Abstract This system based on 51 SCM control unit, used for LM2576-wild numerical control a switching power supply of fuzzy digital control technology, adjust load R1, R2 proportion to change occupies empties compared to make the output stability, and can be through the buttons, digital display to realize output voltage numerical control. In addition, the system to input pressure, flow, input output flow, switch tube overheat as well as the protection circuit, ensure that the system is stable and reliable. Key words: the numerical control switch power supply，LM2576-wild，microcontroller CONTENTS The first chapter design task 1. Basic requirements 2. Play a part The second chapter overall scheme comparison and compared In the third chapter of the system hardware design (a) The design of the whole system 1. The system design thought 2. The block diagram of the whole system (b) Unit circuit function and the analysis of the operation 1. Minimum AT89S52 SCM system 2. Rectifier circuit 3. The power circuit 4. LM2576-A DJ voltage circuit 5. The whole wave output rectifier circuit parameters are calculated 6. Over-voltage protection The fourth chapter system software design 1. The flow chart of the whole system Chapter 5 system commissioning 1. The software debugging 2. Hardware debugging 3. The machine commissioning Chapter 6 system tests 1. The test project circuit 2. Testing instruments 3. Test resultsThe first chapter tasks and requirements (a) The task Design and construction of a switching power supply, its structure diagram shown as shown in figure 1 (b) Requirements 1, basic requirements (1) Basic specifications: input voltage: + 10 V/DC (fluctuating range 8 to 12 V) Output voltage: + 2.5 V/DC ~ + 6.5 V/DC (2)The basic technical index: The output of subsection power shift, and 8 from + 2.5 V to 6.5 V +,