ansys命令1.doc

ansys初学者命令手册 ************************************************************************** BEGINNERS GUIDE TO ANSYS COMMANDS *************The symbol * corresponds to the following:* -- k, l, a, v, e, n, cm, et, mp, r where ==k -- Keypointsl -- Linesa -- Areav -- Volumese -- Elementsn -- Nodescm -- component（元件）et -- element type（元素类型）mp -- material property（材料性能）r -- real constant（常实数）$ -- d, f, sf, bf, ic, where ==d -- DOF（自由度） constraint（约束） (ux... in Structural, Temp in thermal,f -- Force Load ( Heat in thermal)sf -- Surface load on nodesbf -- Body Force on NodesMore Commands can be generated by sensible combinations of $* commands. See the following list of $* possible options$* -- dk -- DOF constraints on KP (Vx,Vy,Pres... in CFD)dl -- DOF constraints on Linesda -- DOF constraints on Areasfk -- Force on Keypointssfl -- Surface load on Linessfa -- Surface load on Areassfe -- Surface load on element facesbfk -- Body Force on Keypointsbfl -- Body Force on Linesbfa -- Body Force on Areabfv -- Body Force on Volumesbfe -- Body Force on Elementsic -- Initial Conditions,p -- If ,p was issued at the end of the Command(in Input WinGUI based picking menu will be activated. Useful for listing, plotdeleting, etc..*************************************************************1. Listing of picked Entities:COMMAND SYNTAX: *LIS,p $*LIS,pA few Combinations of this command are:klis,p -- List KPllis,p -- Lists Linesalis,p -- Lists Areasvlis,p -- Lists Volumeselis,p -- Lists Elementsnlis,p -- Lists Nodescmlis,p -- Lists componentscslis,p -- Lists user created local co-ordinate systems（坐标系）dlis,p -- Lists DOF constraints specfied on nodesdalis,p -- Lists DOF constraints applied on Areasflis,p -- Lists force on Nodessfllis,p -- Lists Surface Load on linesbfalis,p -- Lists body force load applied on Areasiclis,p -- Lists Initial condition on NodesIf ,p was not issued, all entites currently selected will be lisFor certain commands ,