模具专业英语答案.docVIP

英语答案 10133班 张佳 201001030301 一 actuating force feed hopper thermoplastic resistance to slipping extrusion screw 安全系数 极限抗拉强度 倒置落料模 打杆 尺寸公差 二 ×√×√√ 三 1、热塑性塑料:热塑性塑料受热软化、熔融，冷却后就固化定型。如果再加热又可软化熔融和冷却固化定型，如此反复，这一过程没有化学变化。 2、Mica is used for molding plastic parts with superior dielectric characteristics. 3、加入模腔的塑料剂量须精确计量，这取决于零件的壁厚。 4、对U形(槽形)弯曲力大致是V形弯曲力的两倍；打弯力为V形弯曲的1/2。 四 1、How many types of molds are there for compression molding?What are they？ positive molds/landed positive molds/flash-type molds/semipositive molds. 2、List the five types of presses. open side press 开式单柱压力机 open-back inclinable press 开式双柱可倾力机 gap-frame press C型压力机 straight side press 闭式双柱压力机 press brake 弯板机/弯边机 double-action press 双动压力机 knuckle press 曲柄连杆式压力机 triple action press 三动压力机 3、There are several heat treating processes are involved in ferrous materials， What are they？ normalize 正火 spheroidiz 球化处理 anneal 退火 harden 淬火 temper 回火 case harden 表面淬火 stress relieving 应力消除热处理 carburize 渗碳 quench-hardening 淬火硬化 五 Conventional Single Stage Plunger Type: 1.Plastic powder is loaded into the feed hopper and a certain amount feeds into the heating chamber when the plunger draws back. This plastic powder under heat and pressure in the heating chamber becomes a fluid. Heating temperatures range from 265 to 500℉. After the mold is closed, the plunger moves forward, forcing some of the fluid plastic into the mold cavity under pressures ranging from 12，000 to 30，000 psi. Since the mold is cooled by circulating cold water, the plastic hardens and the part may be ejected when the plunger draws back and the mold opens.