OSPF实验1 点对点OSPF基本配置.docVIP

OSPF实验一 点对点OSPF基本配置 一、实验目的 掌握在专线（点对点）上配置OSPF路由协议。 应用场景：企业的总部和分支之间通过E1、POS等WAN专线技术互联，为些需要在专线上配置并运行OSPF路由协议。 二、实验设备 两台Cisco 7206 VXR 中由器、IOS版本 Version 12.3(5)。 三、实验拓扑 四、实验步骤 基本配置： 设备命名。 用Ping命令测试总部和分部链路的连通性。 按照拓扑图配置好接口IP和接口描述信息。 OSPF配置： 启动OSPF进程并配置Router-ID。 把相关接口放入OSPF进程并绑定特定的区域。 五、配置命令 R1 enable configure terminal hostname R1 no ip domain-lookup line console 0 logging synchronous interface loopback 0 ip address 1.1.1.1 255.255.255.255 no shutdown interface loopback 1 ip address 192.168.1.1 255.255.255.0 no shutdown interface serial 1/0 ip address 10.1.1.1 255.255.255.252 no shutdown exit router ospf 1 router-id 1.1.1.1 network 10.1.1.1 0.0.0.0 area 1 network 192.168.1.1 0.0.0.0 area 1 R2 enable configure terminal hostname R2 no ip domain-lookup line console 0 logging synchronous interface loopback 0 ip address 1.1.1.2 255.255.255.255 no shutdown interface loopback 1 ip address 192.168.2.1 255.255.255.0 no shutdown interface serial 1/0 ip address 10.1.1.2 255.255.255.252 no shutdown exit router ospf 1 router-id 1.1.1.2 network 10.1.1.2 0.0.0.0 area 1 network 192.168.2.1 0.0.0.0 area 1 六、测试结果 1、使用Show ip rout查看路由表。 R1#show ip route Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2 i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 ia - IS-IS inter area, * - candidate default, U - per-user static route o - ODR, P - periodic downloaded static route Gateway of last resort is not set 1.0.0.0/32 is subnetted, 1 subnets C 1.1.1.1 is directly connected, Loopback0 10.0.0.0/30 is subnetted, 1 subnets C 10.1.1.0 is directly connected, Serial1/0 C 192.168.1.0/24 is directly connected, Loopback1 192.168.2.0/32 is subnetted, 1 subnets O 192.168.2.1 [110/65] via 10.1.1.2, 00:00:40, Serial1/0