linux一些总结.doc

ex8300 和 freebsd6.1 32bit 安装 B.If a CDROM is used as working media, please follow the instructions below: ?First of all, prepare a blank CD. Use the CD image burning tools ?(eg. nero) under Windows or Unix(Linux, FreeBSD etc.) systems to burn ?the driver image (freebsd6.0_i386_st.iso) into the blank CD. ?You should see freebsd6.0_i386_st.iso and README.TXT and ?freebsd6.0_i386_st.img after unzipping the driver package. ?Please be DOUBLE sure that you have made the correct driver disk before continuing. ?(A).Install FreeBSD on EX43xx/EX83xx/EX123xx/EX163xx SuperTrak Card: ??1.Boot from the FreeBSD install CD. When the console prints a menu list,??please choose 6. Escape to loader prompt, and then, press any key??(except Enter of course) to enter the OK prompt. ??2.Take out the FreeBSD install CD, and insert this customized CD. Under ??the OK prompt, type the following commands: ???load /shasta.ko?????and then take out the CD, insert the FreeBSD install CD, continue the ??installation process by type:?????boot ??and install FreeBSD system into a RAID on the EX43xx/EX83xx/EX123xx/EX163xx ??SuperTrak card.???3.When the installation is complete, do NOT exit instantly. Press ??Alt+F4 to switch to another screen, type the command:????umount /dist????and take out the FreeBSD install CD, insert the customized CD again, ??type the following commands: ???mount /cdrom???/cdrom/install ??and wait the commands to finish. Type the following commands:????umount /cdrom????Take out the customized CD. Insert the FreeBSD install CD again, type:??????mount -t cd9660 /dev/acd0 /dist ???找不到acd0,用cd0？?????Press Alt+F1. Now you can exit the installation. ??After reboot, your system should be up.??(B).Use disks on EX43xx/EX83xx/EX123xx/EX163xx SuperTrak card as data drives: ??It is rather simple. Insert the customized CD, and type the following ??commands: ???mount /cdrom???/cdrom/load ??and the RAID targets on EX43xx/EX83xx/EX123xx/EX163xx SuperTrak c