一种新非轴对称端壁成型方法的数值研究_郑金.pdfVIP

22 9 Vol.22 No.9 2007 9 Journal of Aerospace Power Sept. 2007 : 1000-8055(2007) 09-1487-05 郑 金, 李国君, 李 军, 张兄文 ( , 710049) : , . N-S , , .: , , 71 5%, 51 6% . : ; ; ; ; : TK263 : A Numerical research on a new non-axisymmetric endwall profiling method ZH NG Jin, LI Guo-jun, LI Jun, ZHANG Xiong-wen (School of nergy and Power ngineering, Xi. an Jiaotong University, Xi. an 710049, China) Abstract: Based on the mechanism of secondary flow formation and development in a turbine cascade, SIN function and polynomial function were applied to develop a non-axi- symmetric endwall profiling method. Three-dimensional Reynolds-Averaged Navier-Stokes solution was used to study the flow characteristics of the transonic linear turbine cascades de- signed by non-axisymmetric endwall profiling method. And,the effect of this method and its influence on the flow characteristics of cascade were analyzed and discussed. T he numerical results show that, the established non-axisymmetric endwall could suppress and delay effi- ciently the development of secondary flow vortex system in the cascade passage, and the total pressure coefficient along entire cascade passage declines remarkably. T he maximum ampli- tude of the profiling method is preferably set to 7.5% span, and the total pressure loss at ex- it reduces by 5.6%. Key words: aerospace propulsion system; secondary loss; non-axisymmetric endwall profiling;turbine cascade; numerical simulation , [ 1] 30% ~ 50%. 1994 , Rose :