直立式浸胶法制备环氧树脂涂覆玻璃纤维_从小晔.pdfVIP

40 10 Vol.40No 10 38 2012 10 ENGINEERING PLASTICS APPLICATION Oct. 2012 doi:10.3969/j.issn.1001-3539.2012.10.009 * 210009 EPE– E–GFPEEK E–GF GF E–GF TQ323.5 A 1001-3539(2012)10-0038-05 Glass Fiber Coated with Epoxy Resin Utilizing Up-Right Soaking Glue Technology Cong XiaoyeWang XiaojunDai Baoying College of Materials Science and EngineeringNanjing University of Technology Nanjing 210009 China Abstract: Up-right soaking glue technology was designed and utilized in this work to manufacture the E-glass fiberE–GF coated with epoxy resinEP.Due to the up-right soaking glue technology and the application of polyetheretherketonePEEK roll coater in the processthe gel contentthe homogeneity of resin coating layer and the tensile load of the coated E–GF were better than those of the immersion soaking glue technology and the hand-by soaking glue technology.The research results illustrated that the diluent agent exerted a critical influence on gel content and the temperature of resin glue was essential for the tensile load of the coated E–GF respectively.The result of Scanning Electron Microscopy proved that the glue layer on the surface of E–GF was homogenous and the coated E–GF exhibited a level break under the tensile forcewhich improved the tensile load of the coated E–GF. Through the Fourier-Transfer Infrared investigationthe cross-polymerization of the epoxy resin was proved to be the same for the up-rightimmersion and hand-by soaking glue technology.The variation of the gel content and the homogeneity of resin coating layer affected the tensile property of the coated E–GF. Keywords: glass fiber soaking glue technology epoxy resint ensile load GF GF GF GF 12–14 1–2