基于1-3压电复合材料的穿透式500KHz+高灵敏度水浸探头设计与应用.pdfVIP

基于 1-3 压电复合材料的穿透式 500KHz 高灵敏度 水浸探头设计与应用 纪轩荣，龙绍军，林学武，谭大基 （广州多浦乐电子科技有限公司，广州，510663） 摘 要：本文介绍了一种基于 1-3 压电复合材料发射型和接收型晶体分别独立设计的穿透式 500KHz 高灵敏度水浸探头，该探头应用于厚壁高衰减复合材料穿透式检测。为了使得探头的灵敏度 达到最高，在有源材料的选择上，从理论上分析和论证了将压电晶体设计成 1-3发射型和接收型复合 材料晶体的必要性和优越性；在声学叠层的设计上，从能量最高利用率的角度出发论述了整个设计的 原则和参数选定。最后将按照上述参数制作的一对探头应用于高衰减材料的检测，将结果和常规探头 做了对比，证明了按照该方案制作的探头具有明显的优势（灵敏度高出近 7dB，实际检测中信噪比高 出近 13dB）。 关键词：1-3压电复合材料；超声；水浸探头 1-3 Piezo-composite based on 500KHz High Sensitivity Transmissive Immersion Probe Design and Applicaiton JI Xuan-Rong, LONG Shao-Jun, LIN Xue-Wu, TAN Da-Ji (Guangzhou Doppler Electronic Technologies Co., Ltd, Guangzhou, 510663, China) Abstract: This paper presents a 1-3 piezoelectric composite based on transmite and reception crystal independently designed transmissive immesion 500KHz high sensitivity probe. The probe used in thick-walled high-attenuation composite material detection. In order to make the highest sensitivity of the probe, from theoretical analysis and demonstration of the 1-3 piezoelectric crystal designed to transmit and receive type crystal composite material is necessary and superior. For the acoustic stack layer design, the highest energy efficiency from the perspective of the whole discussion of design principles and parameters selected. Finally, in accordance with the above parameters used in the manufacturing of a pair of probes. The probes used on high-attenuation material test, the results of conventional probes will do a comparison, that the probe produced by this design has obvious advantages (sensitivity high nearly 7dB, the actual detection of signal to noise ration high nearly 13dB). Keywords: 1-3 piezoele