某科研办公楼框架结构设计 土木工程-毕业设计.docVIP

本科毕业设计 某科研办公楼框架结构设计 某某某 燕 山 大 学 2012年6月 本科毕业设计 某科研办公楼框架结构设计 学院（系）： 里仁学院 专 业：土木工程（民建） 学生 姓名： 某某某 学 号： 答辩 日期：2012年6月17日 摘要 本设计层，总建筑面积约平方米。层高3.米。主体采用框架结构体系，填充墙采用混凝土砌块墙，基础采用独立基础。 Abstract The body of this design is a 5-story cultivating building, and the total floor area is about 5,467 square meters. The main height of the floor is 3.8 meters. The body uses the portal frame construction system, the packing wall uses the hollow clay block, and the foundation uses the pile foundation. The purpose of the designs is to make me farniliar with procedure and method of high-floor architectural designs, to master the whole process-from outline design, sophisticated design, to structural one. Strictly according to the sequence of practical design, architectural and structural designs are carried out wholy and detailedly. Contents of the design are as following: outline design for architecture bar disposal for every floor planks, floor beams and ceiling planks, internal force analysis by means of Layer Division for rows of a horizanfal frame and a longitudinal one affected by vertical load, internal force analysis and deformity’s checking computations by means of D-value for rows of a horizontal frame and a hngitudinal one affected by horizontal load, internal force composing: cross-sectional designs and joints designs for frame beams and columns and columns ,calculations and reinforcing bar disposal for stairs and basis. Lots of parameters are gathered by the form of tables. The consultation and use method of standards have been familiarized and preliminarily mastered. All the above-presented exposition could be used for reference in my future career. Keywords: Structural design; Analysis of internal forces; Checking deformation; Combination of internal forces 目 录 摘要 I Abstract