Arc Flash Specification.docVIP

Arc Flash Specification OBJECTIVE The purpose of this project is to provide a complete arc flash program for XYZ Company to help protect individuals working on its premises from electrical arc flash hazards. These individuals may include any workers who inspect, maintain or operate energized electrical equipment. The program shall bring XYZ Company into compliance with the applicable standards for new installations (NEC) and for worker safety in operating facilities (OSHA 29 CFR 1910, NFPA 70E-2004). The program shall assist XYZ Company with improving the reliable operation of the electrical system. PROJECT SCOPE  System Data The supplier shall provide an up to date electrical system single-line diagram as required by NFPA 70E, 2004 Edition, “Standard for Electrical Safety in the Workplace”, as referenced in OSHA 29 CFR 1910 Subpart S, Appendix A. This information shall include nameplate data for electrical components (e.g. transformers, medium voltage switchgear, panelboards, switchboards, motor control centers, etc.) for all portions of the electrical system from the utility intertie through the lowest rated panel. Cable sizes, types and lengths between electrical equipment components and up to date utility source data shall be provided for an accurate single-line representation of the electrical system. Unique characteristics of the equipment installation shall be provided which may impact the magnitude of the potential hazard (e.g. open space versus enclosure). Overcurrent device settings shall be verified. Data collection may require removal of barriers, opening of front panels, etc. while equipment is energized. The supplier must provide proof (written documentation) that its employees working on the premises of XYZ Company have been properly trained in the use and application of personal protective equipment (PPE) and the hazards of working on or near energized equipment. The supplier must provide its own PPE protection with a minimum arc thermal pe