Cisco waas_部署模式.pdfVIP

Cisco Wide Area Application Services Quick Configuration Guide Software Version 4.0.1 Published Date: October 31, 2006 This document describes how to perform a basic configuration of a Wide Area Application Services (WAAS) network that uses the Web Cache Communication Protocol (WCCP) and has three WAAS devices: • WAAS Central Manager • Core Wide Area Application Engine (WAE) • Edge WAE The example in this document also shows how to verify that the WAAS application acceleration feature is working properly after you have completed a basic configuration of your WAAS network. Throughout this document, the term WAAS device is used to refer collectively to WAAS Central Managers and WAEs in your network. For detailed command syntax information for any of the CLI commands that are mentioned in this document, see the Cisco Wide Area Application Services Command Reference . This document contains the following sections: • Autoregistration of WAEs, page 2 • Network Configuration Overview, page 2 • Configuring the WAAS Network, page 4 • Documentation and Support Information, page 21 Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA © 2006 Cisco Systems, Inc. All rights reserved. Cisco Wide Area Application Services Quick Configuration Guide Autoregistration of WAEs Autoregistration of WAEs Autoregistration automatically configures network settings and registers WAEs with WAAS Central Manager. On bootup, devices running the WAAS software (with the exception of the WAAS Central Manager itself) automatically discover WAAS Central Manager and register with it. You do not have to do any manual configuration on the device. Once the WAE is registered, you must approve the device