Pipe thread-a管螺纹.docVIP

Pipe thread 管螺紋 Two common pipe thread sizes exist, the tapered National Pipe Thread (NPT) and the straight National Standard Free-Fitting Straight Mechanical Pipe Thread (NPSM). The tapered threads are for joining and sealing, the straight threads are only for joining. The Dry-seal thread (NPTF) allows for joining without sealants. Three less common threads exist, the Garden Hose Thread (GHT), Fire Hose Coupling (NST) and British Standard Taper Pipe Thread (BSPT). The NPT and NPTF threads are interchangeable with sealants such as PTFE tape. None of the other thread standards are interchangeable. Female NPT threads can be designated as FPT and male NPT threads can be designated as MPT. Pipe sizes do not refer to any physical dimensions. The outside diameter of each pipe or fitting must be measured and compared to the table for size identification. For example, a 3/4 NPT pipe thread has an outside diameter of 1.050 inches. Each thread size has a defined number of threads per inch (TPI). The 3/4 NPT pipe thread has 14 threads per inch. Both the TPI and OD of the thread are required for positive identification of thread size because several sizes have the same TPI. Nominal Pipe Size (NPT) Threads Per Inch Approximate Caliper Measurement 1/8 27 0.38 1/4 18 0.55 3/8 18 0.63 1/2 14 0.80 3/4 14 1.00 1 11.5 1.25 1-1/4 11.5 1.55 1-1/2 11.5 1.80 2 11.5 2.30 Definition of pipe thread acronyms NPT National Pipe Thread FPT Female Pipe Thread MPT Male Pipe Thread PTF SAE short tape pipe thread NPTF American National taper pipe thread for dryseal pressure-tight joints NPSM American National straight pipe thread for mechanical joints NPSI American National straight intermediate pipe thread 管螺紋的規範及用途???? PT(英制管用推拔螺紋)??????? 以癰是使用面直角的螺紋峰,現在將規格統一爲軸直角者.JIS定爲耐密用而組全外螺紋和內 螺紋.?PT外螺紋除了配合PT內螺紋,有時也配合PS. ????? PS(英制管用推拔螺紋用平行內螺紋)????????? 屬於JIS內PT的規格,舊JIS裹有外螺紋,現在已被取消,對方的外螺紋規定要有用PT.(耐密用) ????? PF(英制管用平行螺紋)??????? JIS所定的機械接合螺紋,外螺紋與內螺紋成一對,許容差之設定與PS不同,採用一般固定螺 釘方法,外螺紋在