SCF-1020B全自动水性覆膜机涂胶部分设计.docVIP

宁学院 毕业设计(论文) 所在学院 专 业 班 级 姓 名 学 号 指导老师 年 月 日 关键词：水性干式覆膜机，结构设计，三维建模 Abstract This paper introduces the development situation of waterborne dry-type laminating machine, design principle of water dry-type laminated machine coating structure, analysis of the overall scheme of water dry-type laminated machine glue and determine the mechanical drawing, drawing water dry-type laminated machine coating structure design content includes the gluing mechanism, calculation of water dry laminating machine, conclusion and suggestion of structure design of glue mechanism water dry-type laminating machine The structure is mainly composed of feeding, to film, adhesive, pressing. Motor powered by a belt wheel deceleration will need to transfer the power to the belt wheel, belt wheel drives the ceramic coating roller, so as to drive the movement of the device Abstract this thesis research: (1) water dry-type laminated machine overall structure design. (2) analysis of water dry-type laminated machine performance. (3) the choice of motor. (4) transmission system, execution unit and a water dry-type laminating machine. (5) the design of components for the design calculation and check. (6) the use of computer aided design, 3D modeling on Design of parts. (7) to draw the assembly drawing and parts assembly diagram and parts diagram design. Keywords: water dry-type laminating machine, structure design, 3D modeling 目 录 摘要 II Abstract III 第1章 水性干式覆膜机的发展状况 1 第2章 水性干式覆膜机涂胶部总体方案分析及确定 5 2.1 涂胶部整体工作图 5 2.2涂胶部各个部分的功能介绍 5 2.3压合部分 8 2.3.1压合部分的功能 8 2.3.2热压合装置的工作原理 8 2.3.3压合装置的调节原理 8 2.4 涂胶部设计参数 9 2.5 确定电机所需功率 9 2.6传动比分配 11 第3 章 水性干式覆膜机涂胶机构的计算 13 3.1 带传动设计 13 3.2选择带型 14 3.3确定带轮的基准直径并验证带速 14 3.4确定中心距离、带的基准长度并验算小轮包角 15 3.5确定带的根数z 16 3.6确定带轮的结构和尺寸 16 3.7确定带的张紧装置 16 3.8齿轮的设计计算 18 3.9 轴的设计 24 3.10涂胶辊轴的设计 31 3.11 键的选择与校核 33 3.11.1 带轮1上键的选择与校核 33 3.11.2 带轮2上键的选择与校核 35 3.12墙板受力分析 36 结论与建议 39 参考文献 41 致谢 42 水性覆膜机：使用水性环保胶水覆膜的机器。 覆膜就是将塑料薄膜涂上粘合剂，将其与以纸张为承印物的印刷品，经橡皮滚筒和加热滚筒加压后合在一起，