首秦公司淬火机水冷控制系统改进设计应用.pdfVIP

首秦公司淬火机水冷控制系统改进设计及应用 张 强 刘晓辉 邱志宏 董占斌 丁志勇 田士平 王 普 （秦皇岛首秦金属材料有限公司，秦皇岛 066326 ） 1 摘 要 本文介绍了首秦公司结合水电钢生产中存在的问题，对淬火机控制系统进行的一系列改进设计工作：将原 有单一的淬火模式，改进为跟踪淬火模式、淬火加摆动模式两种不同的控制模式。跟踪淬火模式通过跟踪钢板头尾 位置对淬火机低压区快切阀进行相应的开关控制，解决了厚板淬火时长时间大流量喷水，破坏高位水箱供水平衡的 问题；淬火加摆动模式通过降低钢板通过高压区时的速度，同时使钢板尾部出高压区后在低压区内摆动降温，解决 了厚板淬火时钢板淬透性不好、终冷温度高的问题。 关键词 跟踪淬火模式 淬火加摆动模式 分组控制 顺序控制 The Improvement Design And Application of Quench Cooling Control System In Shouqin Company Zhang Qiang Liu Xiaohui Qiu Zhihong Dong Zhanbin Ding Zhiyong Tian Shiping Wang Pu (Qinhuangdao Shouqin Metal Materials Co.,Ltd., Qinhuangdao, 066326) Abstract Combined with the existing problems of producing the hydropower station steel in Shouqin company, the paper introduces a series of improving design work for the control system of the quench. We change the original single quenching mode to two different control modes that are tracking quenching mode, quenching oscillating mode. Tracking quenching mode is that we perform the on-off control at shut off valve of the quench low pressure area by tracking the head and tail position of the plates. It solves the problem that water spray too much and destroy the water supply balance of the high water tank during quenching. Quenching oscillating mode is that we solve the problem of bad harden ability and high final cooling temperature during thick plates quenching by lowering the transport speed when the plates go through the high pressure area and oscillating cooling at the low pressure area when the tail of the plate go through the high pressure area. Keywords tracking quenching mode, quenching oscillating mode, grouping control, sequence control 1 项目背景 目前中厚板厂使用的直接淬火设备主要是辊式压力淬火机，这是一种连续式淬火装置，它将经过热处理 炉加热后（900℃）的钢板先经过两对大直径的平整辊平整，然后送入高压喷淬区使钢板宽度和长度方向均 匀淬火，再送入低压喷淬区降温以保证钢板的性能。这种辊式喷淬生产的钢板性能比较均匀，瓢