液晶显示时钟.doc

#include reg52.h #include stdio.h #include intrins.h #define uchar unsigned char #define uint unsigned int sbit RS=P2^1; //LCD片选信号 sbit RW=P1^5; //LCD读写信号 sbit E=P1^6; //LCD使能信号 sbit SCLK=P3^4; //DS1302时钟信号 sbit IO=P3^6; //DS1302数据信号 sbit RST=P3^5; //DS1302片选信号 #define write_protect 0x8e //写保护地址 #define DataPort P0 #define IO_R IO //电平读取 //写年周月日时分秒地址 uchar code write_addr[]={0x8c,0x8a,0x88,0x86,0x84,0x82,0x80}; //读年周月日时分秒地址 uchar code read_addr[]={0x8d,0x8b,0x89,0x87,0x85,0x83,0x81}; //空年月日时分秒周 unsigned char time_buf1[8] = {20,12,5,6,9,35,00,2}; //空年月日时分秒周 unsigned char time_buf[8] ; /*------------------------------------------------ 向DS1302写入一字节数据 ------------------------------------------------*/ void write1302(uchar addr,dat) { unsigned char i; RST=1; //写入目标地址：addr addr = addr 0xfe; //最低位置零 for (i = 0; i 8; i ++) { if (addr 0x01) { IO=1; } else { IO=0; } SCLK=1; SCLK=0; addr = addr 1; } //写入数据：d for (i = 0; i 8; i ++) { if (dat 0x01) { IO=1; } else { IO=0; } SCLK=1; SCLK=0; dat = dat 1; } RST=0; //停止DS1302总线 } /*------------------------------------------------ 从DS1302读出一字节数据 ------------------------------------------------*/ unsigned char read1302(uchar addr) { unsigned char i; unsigned char temp; RST=1; //写入目标地址：addr addr = addr | 0x01; //最低位置高