MV2VB错误信息.xlsVIP

Sheet3 Sheet2 Sheet1 Thickness sensor error Thickness sensor time up Thickness sensor foreign matter dropped HC0053M Cassette setting error HC0057M HC0061M HC0062M HC0063M HC0064M HC0065M HC0066M HC0067M HC0068M HC0069M ZA-axis safety detection error Center safety detection error ZA-axis cassette seating detection error ZB-axis cassette seating detection error 1. X/Yaxis did not complete transfer by XY end check timing 1 (197°) or 2 (176°). 2. Cycling timer setting is incorrect. 1. Z-axis did not complete transfer by Z end check timing (166°). 1. NSaxis did not complete transfer by nozzle select end check timing (342°). 1. θaxis did not complete transfer by θ rotation end check timing (338°). 3. Parts cassette is defective. ZA-axis cassette shutter seating detection error 2. SC 1st optical loop disconnected. MC0910 M MC0905 M Board camera scale not set 1. Board camera scale has not been set.部件照相機聚焦範圍沒有設定 MC9040M MMC system error The MMC card is fault.MMC卡失效 1. Make sure that the MMC card has been properly inserted. 確認MMC卡已被正確的插入 2. Make sure the battery for memory backup has proer voltage. 確認備用存儲器的電池正常 3. Turn OFF the OPERATION READY switch once. 關掉OPERATION READY 開關 Recovery data error 1. The recovery data is inappropriate. 恢復數據不合適 2. Recovery operation cannot be executed nomally. 恢復操作無法正常執行 Re-select the program. Note: As PCB production is interrupted, there are unmounted blocks. 從新選擇程式。注意：當PCB生產中斷，會有為貼裝的部分存在 MC9041 M NC0100M X-axis plus limit 1. X axis transfer has exceeded the X axis plus limit. X軸轉動超過X軸上限 2. The X axis plus limit setting is incorrect. X軸上限設定錯誤 2. Check the machine initial setting (recognition basic data) and make sure the parts camera (large) scale has been set. 檢查機器的初始設置（基本識別數據），確認部件照相機（大型）的聚焦範圍已被設定好 1. Check the machine initial setting (recognition basic data) and make sure that PCB camera scale has been set. 檢查機器的初始設置（基本識別數據），確認部件照相機的聚焦範圍已被設定好 4. Press the START key to resume operation. 按下START 鍵恢復運行 3. Memory not attached to the cassett