域控制器崩溃的恢复.doc

域控制器崩溃的恢复 各位转载请麻烦写明作者和出处，谢谢。文章里使用了esx3.5、win2003企业版、vmware converter3.04、winscp、SecureCRT这些软件为了完全模拟真实环境我从公司的域里热克隆来3台机器（域控，备用域控，exchange）,然后归到一个独立的vlan里，现在关闭域控，我们的目的是模拟没有备份系统信息的情况下，域控突然完全崩溃后，把备用域控升级成域控并且把主机名和IP改成和域控一致。这里先说一下esx的一些东西，我这里之说了最少的配置，这些只是能让你使用而已，如果有兴趣各位自己深入研究? ?1??vi /etc/ssh/sshd_config ? ? 2??service sshd restart? ? 3??chkconfig --level 2345 firewall off ? ? 4??chkconfig --level 2345 iptables off 5??service iptables stop然后给esx添加新的一个storageroot@ITEEST root]# fdisk /dev/sdb? ?The number of cylinders for this disk is set to 17684.There is nothing wrong with that, but this is larger than 1024,and could in certain setups cause problems with:1) software that runs at boot time (e.g., old versions of LILO)2) booting and partitioning software from other OSs? ?(e.g., DOS FDISK, OS/2 FDISK)Command (m for help): n? ?? ?? ?? ?? ?? ?? ?? ?? ???Command action? ?? ?? ???? ?e? ?extended? ?p? ?primary partition (1-4)p? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ???Partition number (1-4): 1? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?First cylinder (1-17684, default 1): Using default value 1Last cylinder or +size or +sizeM or +sizeK (1-17684, default 17684): Using default value 17684Command (m for help): x? ?? ?? ?? ?? ?? ?? ?? ?? ?? ???Expert command (m for help): b? ?? ?? ???Partition number (1-4): 1? ?? ?? ?? ?? ?? ?? ?? ?? ???New beginning of data (63-284093459, default 63): Using default value 63Expert command (m for help): r? ?? ?? ?? ?? ?? ?? ? Command (m for help): t? ?Selected partition 1Hex code (type L to list codes): fb Changed system type of partition 1 to fb (Unknown)Command (m for help): wThe partition table has been altered!Calling ioctl() to re-read partition table.WARNING: Re-reading the partition table failed with error 16: Device or resource busy.The kernel still uses the old table.The new table will be used at the next reboot.Syncing disks.[root@ITEEST root]# fdisk ?–lUnable to open –l[root@ITEEST root]# fdisk