开车前后安全检查表.xlsVIP

CompletedORIchecklist Unblocking Settings of Piping Supports 管线支架的松脱和调整 Ensure there is a complete listing of all spring hangers in plant. Ensure each spring hanger is tagged. 确保工厂有一份完整的弹簧吊钩清单，保证每个弹簧挂钩都有独立的标签。 Verify following hydro-testing, checks were completed to ensure that all spring hangers and expansion joints have been unblocked and shipping braces removed. 确认液压试验完成后对系统进行了检查，所有的弹簧吊钩和膨胀节已放松，运输包扎物已去除。 Check and adjust all spring hangers to ensure they are at correct setting. 检查并调节弹簧吊钩，使它们处于正确的位置。 Piping QA /QC / Pressure Testing 管线质量保证（QA）、质量控制（QC）和压力试验 Verify material certificates have been reviewed where required by Engineering for Mechanical Integrity of Plant 确认已按工厂的机械完整性设计要求对材料合格证进行了审查。 Confirm weld procedures and welder qualification records are onsite and have been reviewed by a qualified engineer. Confirm that there is documentation that welding procedures have been followed. 确认现场有焊接程序和焊工资质记录，并且经过合格的工程师审查。确认有文件可以证明焊接作业遵守了相关的焊接程序。 Verify checks have been made to ensure that the specified % radiography has been performed. Verify that records have been maintained to document that welds which failed initial radiography have been repaired. 确认已进行了检查，保证已按照要求的射线探伤百分比对焊口进行了检查。确认保存了相关的记录，确认那些焊口在首次检查发现了缺陷的焊接处已经得到修复。 同上 NA Verify checks were made to assure that all temporary shipping supports have been removed from equipment. Check against list provided by fabricator/designer if available. 确认所有的设备的临时运输支撑物已经去除。如果制造厂/设计人员提供检查清单的话，用该清单进行对照检查。 Verify all utility connections points are tagged: utility steam, utility N2, utility air, breathing air, potable water, demin water, etc. 确认所有的公用工程连接点都已标注：公用蒸汽、公用氮气、公用工厂空气、呼吸空气、饮用水、脱盐水等等。 Inspect steam system to ensure there is adequate steam traps for condensate removal to prevent water hammer. This can be done by verifying that the system was designed per project specific calculations of condensation; and that the installation is per design. 检查蒸汽系统，确保有足够的蒸汽疏水阀，以便排除蒸汽凝液防止发生水锤。可以检查系统是否对冷凝液进行计算和完成检查，并确认安装与设计要求相符。