85零件图的尺寸标注.pptVIP

本 小 节 结 束 * * Dimensioning 零件图的尺寸标注 Datum features 尺寸基准的选择 Direct specifications of important dimensions 重要的尺寸直接注出 Avoiding close dimension chains 避免出现封闭的尺寸链 Producing dimensions in accordance with machining sequence 标注尺寸应符合加工顺序 Only one link allowed between machined and non-machined surfaces 同一个方向只能有一个非加工面与加工面联系 Exercises 练习题 请点击相应标题显示其内容 请点击鼠标左键显示后面内容 Datum features 尺寸基准的选择 When selecting a datum, one must consider the part position, function, assembling, position setting and measurement. Therefore, datum features should be determined according to the design’s requirements, machining conditions, and measurements. 在选择尺寸基准时, 必须考虑零件在机器或部件中位置、作用、零件之间的 装配关系以及零件在加工过程中的定位和测量等要求。因此, 基准应根据设计要求、加工情况和测量方法确定。 Design datum This class includes datum planes or datum lines used to locate a given part inside other parts. 设计基准 是用于确定零件在部件中工作位置的基准面或线。 Process datum This class includes datum plane or datum line used to machine or measure the parts. 工艺基准 是零件在加工、测量时的基准面或线。 Determining datum features 尺寸基准的确定 请 点 击 鼠 标 左 键 显 示 后 面 内 容 Datum features 尺寸基准的选择 This section focuses on some general issues of dimensioning and some commonly used structures so that the dimensions will not only meet the design requirements but also other requirements to facilitate machining, measurement and inspection. 使所标注的尺寸既能满足设计要求,又符合生产实际, 便于加工、测量和检验。 Select the bottom surface D as the datum for the dimension of the center height of the bracket’s axle hole. 标注支架轴孔的中心高，应以底 面D为基准 The dimensions of the two threaded holes select datum face B、C. 底板两螺孔的 定位尺寸,以B、C为基准 It is easy to use datum E to measure the depth of the threaded hole. 以E为基准测 量螺孔的深 度比较方便 Process datum 工艺基准 Design datum 设计基准: B、C、D Length datum 长度基准 B D Height datum 高度基准zzzz Width datum 宽度基准 C Process datum 工艺基准: E Bracket 支架 The dimensio