汽机房行车吊装作业指导书JSA ok.docVIP

JOB SAFETY ANALYSIS 工作安全分析 Date（日期 ）：2004-2-20 Job Title: Ground assembles of overhead crane 工作名称:行车的地面组合 LOCATION :Turbine building site 地点:汽机房现场 JSA No JSA编号: JSA-8560-8101-0181-A DEPARTMENT : Steam turbine department 部门：汽机施工处 SUPERVISOR TITLE OF PERSON WHO DOES JOB 主管人 : 工作执行人职务: PREPARED BY 编制： REVIEWED BY 审查: APPROVED BY 批准： Environmental Conditions环境条件 Insid内部 Outside外部 Cold冷 Heat热 Wet 湿 Dust 灰尘 Vapors/Mist 水汽 Noise 噪音 Vibration 震动 Other 其它 Heavy Rain 大雨 Primary Job Functions Position 基本工作行动 Lifting举重 Grasping抓取 Pushing推 Sitting 座 Reaching延伸 Bending弯曲 Kneeling 跪Standing直立 Pulling拖 Squatting 蹲 Other其它 SEQUENCE OF BASIC JOB STEPS工作步骤 POTENTIAL HAZARD 潜在危险 风险评估RAM （H 、M、L） RECOMMENDED ACTION OR PROCEDURE 控制行动措施 ACTION BY 执行人 DATE DUE 完成日期 REMARK 备注 Frame assemble and installation 框架的组合、安装 (3)滑倒、绊倒或坠落 M All constructors should wear their PPE; Mind the steps when walking and don’t be careless, in particular, be aware of being tripped by rebar during adjusting the frame; Set the warning line on both sides of the construction area, and irrelative persons not allowed to enter without permission; Use the eligible ladder inspected by BSF when the constructors are going up and down the frame. Hold the handrail firmly when going up and down the ladder ; Make good use of the safety belt if working in high. .施工人员要穿戴好各自的PPE； 行走时要注意脚下，不要一心二用，特别是框架就位后调整时，严防被钢筋绊倒；施工时，在施工区域两侧拉好警戒绳，无关人员严禁进入；施工人员上下框架时，要使用BSF检验合格的梯子。施工人员上下梯子时，两手要紧抓扶手;存在高空作业时要正确使用安全带。 Frame assemble and installation 框架的组合、安装 (6)移动物体打击 L Place the unused material at the settled location in order to prevent the unsteadied material from injuring someone. 未使用的材料，应放置在固定的位置，防止材料放置不稳伤人。 (16)工具伤害 M Strictly prohibit throwing to pass tools during construction; 施工时，传递工