基于UG的整体叶轮加工工艺本科毕业设计.docVIP

? 本科毕业设计 ? ? 压气机叶轮加工工艺 ? ? ? ? 目 录 摘要 2 Abstract 3 1. 引言 4 2. 压气机叶轮结构加工工艺分析 4 2.1 压气机叶轮结构分析 4 2.2 压气机叶轮的技术要求 6 2.2.1 对压气机叶轮的设计制作要求 6 2.2.2 对压气机叶轮的加工要求 6 2.2.3 叶轮的加工难点 7 3. 压气机叶轮毛坯的确定 7 3.1 叶轮材料的选择 7 3.2 叶轮毛坯的选择 9 4. 压气机叶轮加工工艺路线设计 9 4.1 加工方法的选择 9 4.2 加工阶段的划分 10 5. 压气机叶轮的工艺设计 10 5.1 机床选择 10 5.2 定位基准、夹紧方案的确定 11 5.3 刀具选择 12 5.4 进给路线和工步顺序的确定 13 5.4.1 加工坐标系 13 5.4.2 UG 加工及仿真步骤 13 5.4.3 UG 加工及仿真结果与模型的比较 25 6．总结 26 参考文献 28 致 谢 29 压气机叶轮加工工艺 机械工程及自动化 2011级x班 指导教师Centrifugal Fan Impeller Mechanical engineering and automation The class x of grade 2011:Jxxxx ? The instructor: xxxx Abstract: Centrifugal compressor impeller machining is the most common instances of multi-axis linkage nc machining, it is also one of the difficulties in nc machining.This paper introduces in detail the whole process of the impeller machining and processing process matters needing attention, for complex product modeling and nc programming provides design ideas and methods.Main work includes the following aspects: （1）In this paper, according to the actual production situation and the demand of research, using UG8.0 software for the analysis of the impeller.Through processing module cavity milling, variable contour milling, processing method of impeller impeller model of programming, simulation process and post-processing. （2）Adjacent integral impeller blade less space, with the decrease of the radius on the radial channels such as narrow processing difficulties, so the impeller blade curved surface machining besides interference occurs between the cutter and the processing blade, cutting tool is interference with the adjacent blades. （3）Tool planning constraints, automatic generation of tool path is more difficult problems, combined with practical experience, has carried on the processing technology research, identified by Swiss m kronor company Hyde han system five axis machining center as an impeller machining