Femap实例-中面建模及多载荷集的分析.pdfVIP

Exercise 13 – Midsurface Modeling Introduction In this exercise, you will generate a midsurface model of a machined bracket. The steps to complete this exercise are: • Import geometry • Generate and edit midsurfaces • Assign mesh attributes, set mesh sizing and mesh the bracket • Create constraints and loads, including combined load sets • Analyse the bracket using a Multi-set analysis and view the stress results. 13 - 1 Exercise 13 – Midsurface Modeling Step 1: Import geometry Import the Parasolid geometry of the multi-thickness solid model. • Open a new FEMAP model. • Select the File, Import, Geometry command. • Select the Parasolid file ex13-Bracket_inches.x_t from your class Geometry folder. • Click OK to accept the defaults in the Solid Model Read Options dialog box. Change the view orientation to the Trimetric view. • Press the F8 key (or use the View, Rotate, Model command) to open the View Rotate dialog box. • Select the Isometric button. • Click OK to close the dialog box. Save the model • Save the model in your class Exercises folder as “ex13-Bracket.modfem”. 13 - 2 Exercise 13 – Midsurface Modeling Step 2: Create midsurfaces Extract the midsurfaces from the solid. • Select the Geometry, Midsurface, Automatic command. • Click the Select All button to select all the surfaces on the solid. • In the Mid-Surface Tolerance dialog box, click the Measure Distance icon to enable measuring a 3-D distance. Ctrl+D can also be used to measure a distance from the graphics window while in a command. • When the Locate – Define Location to Measure From dialog