基于Arduino的温湿度系统设计.doc

摘 要 Arduino是常用于控制的芯片，在智能仪器、工业检测控制、机电一体等方面。使用Arduino实现温湿度全程的控制，而且Arduino易于学习掌握，性价比高。 基于Arduino的温湿度控制系统一个含有已校准数字信号输出DHT11传感器来环境中的温湿度数据。再通过LCD进行。当环境中的达到临界值报警系统报警。 Arduino设计温湿度控制系统，可以精确的反应的温度以及的变化。完成升温、降温。在温度波动范围内保持恒温将系统应用到温室当中为生长提供适宜的环境。对于，必须温湿度装置对其进行监控。本系统可以及时、精确的反映的的变化。 关键词： Arduino；DHT11；传感器；； ABSTRACT Arduino is relatively commonly used in the control chip, smart instrumentation, industrial inspection control; mechatronics achieved impressive results has been widely applied.also a lot of its strength as the temperature and humidity control system. Able to achieve automatic control of temperature and humidity throughout Arduino, the Arduino is easy to learn and master the high cost-effective. This paper designs a temperature and humidity control system based on Arduino,,the system uses a containing composite sensor DHT11 digital temperature and humidity calibration of digital signal output to temperature and humidity data acquisition in the environment. . After Arduino treatment, and the treatment results through the LCD display display. When the parameters in the environment reaches the critical value, the alarm will sound the alarmsystem. Use a Arduino-type micro-controller design temperature and humidity control system for, instant accurate reaction greenhouse temperature and moderate changes. Complete, such as the temperature was cooled to a specific temperature,raised to a specific temperature. Maintain constant temperature and other control in the volatility temperature range, humidity control is also true. The application of this system to the greenhouse which is no doubt that provides a more suitable environment for vegetation growth. For greenhouse cultivation and flower garden, flower cultivation, you must install certain environmental temperature and humidity device monitor. This system can be timely, accurate reflection of the indoor temperature and humidity changes, able to meet the requirements of the temperature and humidity control. Keywords: Ardu