基于GSM900M升级的EDGE++应用及评估.pdf

网规网优 基于GSM900M升级的EDGE++应用及评估 张治炼 （中国铁塔股份有限公司长沙分公司，湖南 长沙 410000） 【摘 要】 EDGE++ 的本质是FDD-LTE技术，可以通过升级农村的GSM900M且在共用现网TD-LTE 的核心网、PTN传输网 基础上改造完成。硬件上，将GSM900M 的RRU 替换为EDGE++ 的RRU ，BBU侧增加EDGE++ 的基带处理板和 主控板，GSM900M 的天馈资源无需替换。软件上，通过Refarming GSM 工具清理出农村的空闲频率5M ，升级 EDGE++ 的eNodeB 的软件版本，修改GSM900M 的BTS 的相关模式，联调EDGE++ 的eNodeB ，打通EDGE++ 的 eNodeB到EPC之间的PTN传输通道，完成eNodeB站点业务调测。最后，将EDGE++信号通过支持EDGE++ 的MiFi 或CPE终端转换成Wi-Fi信号，在农村提供Wi-Fi热点。 【关键词】 GSM900M EDGE++ FDD-LTE 升级 中图分类号：TN929.53 文献标识码：A 文章编号：1006-1010(2014)-22-0018-04 Application and Evaluation of EDGE++ Based on GSM900M Upgrade ZHANG Zhi-lian (China Tower Co., Ltd., Changsha Branch, Changsha 410000, China) [Abstract] The essence of EDGE++ is the FDD-LTE technology which can be implemented through the upgrade of GSM900M in the rural areas based on the reforms of both the current TD-LTE core network and PTN transmission network. When it comes to hardware, the RRU of GSM900M being replaced by EDGE++ RRU, EDGE++ baseband processing board and control board should be added in the BBU side, while antenna feed of GSM900M remains unchanged. When it comes to software, on one hand, the 5M idle frequency is released using Refarming GSM tool, software version of EDGE++ eNodeB should be updated and the related modes to BTS of GSM900M should be revised. On the other hand, in order to open the transmission channel between EDGE++ eNodeB and EPC, eNodeB should be joint debugged to test eNodeB site service. Finally, EDGE++ signal is converted into Wi-Fi signal through MiFi supporting EDGE++or CPE terminal to provide Wi-Fi hotspot