热轧带钢亮带_冷轧带钢凸棱的成因及解决措施.pdfVIP

　第 43 卷 　第 12 期 钢 铁 　Vol . 43 , No . 12 　2 0 0 8 年 12 月 Iron and St eel December 　2008 热轧带钢亮带/ 冷轧带钢凸棱的成因及解决措施 牛世浦 , 　张乃林 , 　卢少保 , 　尚井泉 (唐山国丰钢铁有限公司热轧薄板厂 , 河北 唐山 063300) 摘 　要 : 针对冷轧带卷的凸棱缺陷 ,对冷轧生产工艺进行适当调整 ,未能完全消除;而同期热轧带钢表面出现了亮 带 ,经过跟踪与测量 ,确定热轧卷亮带位置与冷轧卷凸棱位置有对应关系 ,并提出亮带的实质是轧辊的猫耳状不均 匀磨损导致在带钢厚度方向上形成的局部高点 。通过优化热轧轧辊辊型和其他工艺制度 ,成功地解决了中薄板坯 连铸连轧生产线上热轧带钢亮带问题 , 同时避免冷轧带钢凸棱缺陷 。 关键词 : 冷轧板凸棱 ; 热轧板亮带 ; 轧辊辊型 ; 中薄板坯 ; 连铸连轧 ( ) 中图分类号 : T G335 11 　　文献标识码 : A 　　文章编号 : 0449749X 2008 Reasons and CountorMeasures of Bright/ Band of Hot Rolled Strip and Fin Defect of Col d Rolled Strip N IU Ship u , 　ZHAN G N ailin , 　L U Shaobao , 　SHAN G J in gquan ( Hot St rip Mill of Tangshan Guofeng Iron and St eel Co . , L t d . , Tangshan 063300 , Hebei , China) Abstract : Some adj u st ment of cold rolling t echnolo gy was done to remove fin defect of cold rolled st rip , but it couldn ’t remove t he defect complet ely . At t he same time bright brand was found on surface of hot st rip , and it wa s found t hat t he po sition of bright band on hot rolled st rip might be corresponded to t he po sition of fin defect . It wa s p roved t hat t he bright band was local high point of hot st rip formed by nonuniform wear of t he roller . Through op timizing roller shap e of hot rolling mill t he bright brand on hot rolled st rip and fin defect of cold rolled st rip were e liminat ed . Key words : fin defect of cold rolled st rip ; bright brand of hot rolled st rip ; roller shap e ; medium t hin