服装专业英语复习.docVIP

一、服装部位名称 二、尺寸表翻译 三、工艺说明 1、LOGO位置说明 TNF Logo is placed at Front Left Chest and Back Right Shoulder. Front TNF logo is placed 3 1/2” from CF and 5” from HPS Back TNF logo is placed 4” from CB and 4 1/2” from HPS If there is a yoke, then TNF Logo placement is 1 ?” above or below yoke seam. Fabric Logo centered on Left Sleeve 3” above cuff edge, unless otherwise specified. Down Fill Logo centered on Left sleeve 3” above cuff edge or 1” below the Fabric Logo, unless otherwise specified. 2、衬衫工艺说明 General: 1. 10-12 stitches per inch 2. 516 5-thread safety stitch all seams, unless specified. All topstitching as sketch. 1. 每英寸10-12针 2. 所有缝份用5线包缝，除非有特别要求。所有明线如图所示。 Garment Treatment: 1. Basic garment wash 2. Do not press garment, hold steamer away from garment for natural look 1. 基本成衣水洗 2. 不能直接熨烫，打蒸汽保持其自然的外观 Collar: 1. Interior locker loop at CB neck seam, 1 3/4 wide 1/4 deep, heat cut ends and bartack at seam 1. 领缝后中挂耳宽1 3/4”, 深1/4”，两头热切并打套结。 Front: 1. CF placket is set-on 2. Buttons: top placket button is set 2 3/4 below the neck seam to center, bottom placket button is set 4 3/4 above the finished hem to center, all other buttons are spaced evenly between 3. Chest pocket with invisible zipper closure and 2 Shell A pocket facing clean finished to mesh pocketing. Safety stitch bag closed. Insert bag into CF seam. Stitch top of pocket to shell with single needle topstitich. Zipper closes upward; bartack at pocket opening edges. 1. 前门襟是装襟 2. 前中扣子：前门襟顶部扣子中心距领缝2 3/4，最底一粒扣子中心距底摆4 3/4”。其他扣子间距等分。 3. 胸袋装拉链，拉链隐藏，2”宽光边本身布袋垫布车到网眼袋布上。口袋四周缝线加固。口袋压到前中缝里。袋顶单针明线与面布固定。拉链往上闭合。口袋开口两端打套结。 Sleeve: 1. Sleeve cuff with rounded corners, 1/4 single needle topstitch around 2. One sleeve pleat on back sleeve 1. 圆角袖克夫，压1/4”单针明线。 2. 袖单褶放在后袖片。 Label: 1. Main label insert into CB neckline seam 2. Care/content label placed under main label 3. Security label placed under care label 4. Lot label under security. 1. 主标车到后中领缝里。 2. 洗标、成分标在主标下面。 3. 安全防伪标在洗标下面。 4. 批号标在防伪标下面。 Spare button: attach to left side s