汽车玻璃基础知识.pptVIP

Automotive Glazing Content Automotive glass Laminated glass Tempered glass Glass bonding Automotive glass 1 3 5 4 6 2 3 5 4 6 1 - Windscreen 2 - Rear screen 3 - Front door 4 - Rear door 5 - Front fixed 6 - Rear quarter Function Safety Vision Secrecy Comfort Temperature Acoustics Optics Fashion AM/FM/Telephone/GPS Old C6 New C6 Laminated glass Windshield Door glass Sunroof Cutting Cutting Grinding Small glass Big glass Screen printing Match Bending Washing Tempered glass Rear screen Door glass Quarter glass Fixed glass Sunroof Cutting Grinding Printing Heating Bending Tempering Control Glass bonding Glass Rabbet Glue band Seal Glue before bonding Height of glue: 13mm ? 2mm Width of glue: 8mm ? 2mm H L Glass After bonding 50mm2 ? 15mm2 Glazing bonding process Assemble automatically or manually glazing on vehicle Glazing Rabbet Glazing Rabbet Glazing Rabbet Glazing Rabbet Glazing Rabbet Product specifications 5 mm 10 mm Glue contact with rabbet Glazing Rabbet 10 mm Glue contact with glazing Section glue 50mm2 +/-15 Wedge Requirement If the crushing is realized by individual wedge, the width should be at least: 17+5=22mm If the crushing is realized by continuous wedge, the width should be at least: 15+5=20mm Glass Glue Rabbet width 3mm 15 or 17mm The rabbet should have at least 20mm plan surface next to the bottom of the rabbet. The height of the rabbet should be at least 10mm The radius of the rabbet bottom should not be more than 6mm. The angle of the rabbet should between 90° and 120° Angle between 90° and 120° Thank you for your attention!