ASTMD335909胶带试验用测定粘合性的标准试验方法.pdfVIP

Designation: D 3359 – 09 Standard Test Methods for Measuring Adhesion by Tape Test1 This standard is issued under the fixed designation D 3359; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* of the user of this standard to establish appropriate safety and 1.1 These test methods cover procedures for assessing the health practices and determine the applicability of regulatory adhesion of coating films to metallic substrates by applying and limitations prior to use. removing pressure-sensitive tape over cuts made in the film. 2. Referenced Documents NOTE 1—This test method has been reported being used to measure 2.1 ASTM Standards:2 adhesion of organic coatings on soft substrates (for example, wood and D 609 Practice for Preparation of Cold-Rolled Steel Panels plastic). Issues with plastic substrates are noted in Appendix X1. A similar test method, ISO 2409, permits tests on soft substrates (for example, wood for Testing Paint, Varnish, Conversion Coatings, and and plaster). Precision and bias data on the later is lacking. Test Methods Related Coating Products D 3359 was developed with metal as the substrate and, in the absence of D 823 Practices for Producing Films of Uniform Thickness supporting precision and bias data, is so limited.