低温管道设计LowtemperaturePipingDesign.pdfVIP

Only For Italy TP Co. Jul.1990 Low-temperature Piping Design CONTENTS 1. Scope of use 2. Pipeline Design precautions 2.1 Measures to prevent shrinkage 2.2 cold 2.3 Hanger and Support 2.4 Valves 2.5 Others Page 1 of 6 Italy TP Co. Low-temperature Piping Design Jul.1990 1. Scope of use This provision applies to low-temperature line (- 100 ℃ ~ -164 ℃) in the design, 0 ℃ ~ -100 ℃ low temperature pipelines can refer to this provision. 2. Pipeline Design precautions 2.1 Measures to prevent shrinkage According to B operator round the valve will not be exposed to the outer surface of the valve A cold layer of the principle of determining the minimum block size l. (1) should pay attention to the nature of the pipe Typically used for low-temperature austenitic stainless steel pipes, and its linear expansion greater than carbon steel. Therefore, austenitic stainless steel of the displacement is very large. Since many thin wall stainless steel pipe, so the intensity is lower, so consider these tubes to support the setting. (2) reduce the pipeline contraction force acting on the pipe system, several measures (A) the pipe system using self-expanding. (B) with the expansion loop. (C) use of expansion joints. (D) Note that the displacement In taking measures to absorb the displacement before the pipeline should be calculated at each point and clear, to prevent stent and the beam is pulled down. 2.2 cold Bail on the low-temperature fluids cold temperature protection and isolation from the external e