轮胎专用模具术语(中英文对照).docVIP

Mold Terminology模具术语 AD-Diameter The tread diameter at the centerline of the tread (EU); also: T-Diameter(GT) ? AD直径：指胎面中心线直径（EU）。又叫T直径（GT） Auto-lock Ear A Lug on the cone ring used to mount the mold/container in the top half of a 60“ NRM Auto-lock press. ??导环上的突缘，用于和60“ NRM Auto-lock 硫化机上半部连接。 Bead Ring The tire bead forming ring (also: toe ring) ? 钢圈，也称 toe ring Bead Ring Register The landing and tapered seat that the bead ring fits into ??钢圈配合：侧板上，和 钢圈配合的平面及锥面 Bottom Container Plate The plate that the bottom sidewall plate is bolted to ? 模壳底座 Bottom Container Plate Lifting Lug A lug attached to the Bottom Container Plate with Horizontal holes used for lifting. ?模壳底座吊耳： 装配在底座上、有水平的孔，用来吊装的吊耳 Bottom Container Plate Dowel Pin Lug A lug attached to the Bottom Container Plate that supports the Dowel Pin Bushing. ? 装配在底座上，用来支承定位销套的突缘 Bottom Container Plate Hold Down A lug that is used to fix the Bottom Plate in the Press. ? 用来将底座装配在硫化机上的突缘 Breaker Hook A hook fixed to the bottom of the tread segment that catches the bottom container plate only when the segment will not release from the tire during de-molding. 分离钩：固定在花纹块底部的钩子，轮胎硫化完后若花纹块不能跟轮胎分离，就用此钩抓住模壳底座帮助花纹块和轮胎进行分离。 Breaker Hook Guide Piece A block bolted to the breaker hook that aligns the tread segment with a slot in the bottom container plate. ?? 分离钩导块：用螺栓固定在Breaker Hook上，定位花纹块和模壳底座上槽的定位块。 Bronze Wear Plates Any sacrificial metal plate placed under, over or behind a component to keep the components from wearing on each other (greasing) ? 青铜耐磨板(油润滑的) Casting An un-machined cast metal tread ring or Segment ? 铸件：未加工的金属花纹圈或花纹块铸件。 Centering Ring The ring mounted on the bottom press platen to locate the mold/ container concentrically to the press; also: Press register ??定中环,也称“Press register” Clamp Rings The bladder clamping assembly ?? 胶囊夹盘 Cone Ring The outer ring that transforms the axial movement of the press in a radial one of the segments; also: Actuator ring, Squeeze ring (GT) ??导环，也称Actuator ring, Squeeze ring Con