基于LabVIEW的FuzzyPID温度控制系统的设计陈云霞.pdfVIP

200 8 年11月 控 制 工 程 Nov 1 2 0 0 8 第15 卷第6期 Control Engineering of China Vol. 15 , No. 6 : 1671-784 8( 2008) 06- 0656-03 LabVIEWFuzzy- PID 陈云霞, 芦凤桂, 朱妙凤, 姚 舜 ( , 200240) : 针对电子束加热是在真空室 进行, 能量密度高工件温度变化快控制难度 大数学模型难以建立等特点, 提出了系统解决方案及控制机理利用LabVIEW 软件 的模 糊逻辑模块( Fuzzy Logic) 及仿真模块( Simulation Module) 建立系统仿真程序, 并通过仿真曲线获 得优化参数实验表明, 该控制系统具有动态响应快调整时间短稳态误差小超调量小等 特点, 从而证明了在以高能密度的电子束为加工热源过程 , 采用Fuzzy-PID 控制技术对被加 工件温度进行控制, 可以获得理想的控制效果 : Fuzzy-PID 控制 温度控制 电子束 LabVIEW : TG 156 : A Design of Fuzzy-PID Controller in Temperature System Based on LabVIEW CHEN Yun-x ia , L U Feng-gui , ZH U Miao-f eng , YA O Shun ( Research Centre of Jointing Engineering , Shanghai Jiao Tong University , Shanghai 200240, China) Abstract: According to the f eatures of high vacuum , high energy pow er, f ast rate of temp erature variation and the diff iculty of ex act m athemat- ical model establishing in the temperature control system of electron beam processing, a novel adaptive fuzzy- PID control strategy is proposed . The purpose is to decide a mode from the fuzzy logic and PID control algorithms according to the absolute error of the target value and the mea- sured temperature. To build the simulation block of the control system , the fuzzy logic module and simulation module in NI LabVIEW softw are are used, and the optimized control parameters are obtained from the simulation curves . The experim ent result show s that the new designed controller has good dynam ic characteristic, control accuracy and property of robust . Key words: Fuzzy-PID control temperature control e