《《Eye Analysis -- Transient Analysis》.docxVIP

 HYPERLINK .tw/oldfriend/page75.htm Ansoft Designer 教學 Eye Analysis -- Transient Analysis, QuickEye, VerifEye and IBIS-AMI Analysis 更 新 日 期： 08/02/2012 20:11:30 本文於2011以Designer v6.0示範數種不同的眼圖分析方法(Transient Eye、QuickEye and VerifEye)，與觀察FFE (Feed-Forward Equalization)的效果。2012年新增以Designer v7.0做IBIS-AMI，與補充說明Transient Analysis、Quick Eye、Verify Eye and AMI Analysis的特點差異。  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l Introductions Introductions  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l Open_a_New_Circuit_Project Open a New Circuit Project  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l Transient_Analysis Transient Analysis 3.1 Select components and set them 3.2 Setup transient analysis 3.3 Run analysis , then report  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l Quick_Eye_Analysis Quick Eye Analysis 4.1 Select components and set them 4.2 Setup Quick Eye analysis 4.3 Run analysis , report eye (histogram) and contour 4.4 Set FFE properties 4.5 Run analysis , report eye (histogram) and contour (with FFE)  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l Verify_Eye_Analysis Verify Eye Analysis 5.1 Select components and set them 5.2 Setup Verify Eye analysis 5.3 Run analysis , report bathtub 5.4 Set FFE properties 5.5 Run analysis , report bathtub (with FFE)  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l Combine_All_Eye_Analysis Combine All Eye Analysis 6.1 Select components and set them 6.2 Setup Quick Eye and Verify Eye analysis  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l IBIS-AMI_Example IBIS-AMI Analysis 7.1 Import IBIS-AMI Tx\Rx 7.2 Setup AMI analysis 7.3 Setup Verify Eye analysis 7.4 Run analysis , then report Initial 7.5 Report waveform after receiver 7.6 Cross-talk using IBIS-AMI  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l 問題與討論 問題與討論8.1 Transient Analysis與Quick Eye Analysis的最大差異?  HYPERLINK .tw/oldfriend/Designer/Circuit_Eye.htm \l 參考資料 參考資料 Introductions? 1.1 Download DDR-III I