《卧加系列报警信息中英文》.doc

卧加系列报警信息（中英文对照） EX0018 ALL –AXES A cycle start has been activated without the all-zero-returns after a machine lock cancel NEED ZERO RETURN A33.4 EX0018 所有轴需要原点返回 机床锁住取消后所有轴没有回原点就按了循环启动按钮 EX0019 WORK COUNTER A cycle start has been activated with the PC or external work counter at full count. AT FULL COUNT A32.2 EX0019 工件计数个数达到设定值了 工件计数个数已达到设定值了，再按循环启动按钮就出现上述报警 EX0020 EDITNG KEY SWITCH ON A00.0 A cycle start has been activated with Editing Key Switch on EX0020 编辑键开关打开了 编辑键开关打开时按下了循环启动按钮 EX0021 TOOL IS NOT CLAMPED A00.1 A cycle start has been activated while the tool Is not clamped EX0021 刀具没有夹紧 刀具夹紧按键没有执行按下了循环启动按钮 EX0023 START INTERLOCK A00.2 A cycle start has been activated while an external start interlock signal has been input SIGNAL ON EX0023 EX0026 CLOSE DOOR A00.4 A cycle start has been activated without door closed .Closed the door EX0026 需要关门 操作门没有关上就开始执行循环启动按钮 EX0047 WRONG COMBINATION OF M-CODES A00.7 M codes in same group has been given Or Wrong combination of M codes has been Given EX0047 M代码组合错误 多个M代码放在一个程序行里或者给出了 一个不被识别的M代码 EX0065 SENSOR OVER A24.5 Z-axis sensor over travel signal is activated TRAVEL EX0065 传感器超程 当前所用的传感器超程了 EX0068 INTERLOCK RELEASE A00.5 Door interlock release state has been invalid TIME OVER EX0068 互锁释放超时 操作门互锁释放状态是无效的，检查门锁钥匙是否在开的位置 EX0069 DOOR LOCK TIME OVER A00.6 Door lock complete singnal has not been turned on within