《AT29C010A-12PC+》.pdf

查询29C010供应商 AT29C010A Features • Fast Read Access Time - 70 ns • 5-Volt-Only Reprogramming • Sector Program Operation Single Cycle Reprogram (Erase and Program) 1024 Sectors (128 bytes/sector) Internal Address and Data Latches for 128-Bytes • Two 8 KB Boot Blocks with Lockout • Internal Program Control and Timer • Hardware and Software Data Protection 1 Megabit • Fast Sector Program Cycle Time - 10 ms • DATA Polling for End of Program Detection (128K x 8) • Low Power Dissipation 50 mA Active Current 5-volt Only 100 µA CMOS Standby Current • Typical Endurance 10,000 Cycles CMOS Flash • Single 5V ±10% Supply • CMOS and TTL Compatible Inputs and Outputs • Commercial and Industrial Temperature Ranges Memory Description The AT29C010A is a 5-volt-only in-system Flash programmable and erasable read only memory (PEROM). Its 1 megabit of memory is organized as 131,072 words by 8 bits. Manufactured with Atmel’s advanced nonvolatile CMOS technology, the device offers access times to 70 ns with power dissipation of just 275 mW over the commer- cial temperature range. When the device is deselected, the CMOS standby current is less than 100 µA. The device endurance is such that any sector can typically be writ- ten to in excess of 10,000 times. To allow for simple in-system reprogrammability, the AT29C010A does not require high input voltages for programming. Five-volt-only commands determine the opera- AT29C010A Pin Configurations