《福特汽车表面处理》.pdf

WORLDWIDE FASTENER STANDARD WX100 Date: 2004-09-01 FINISH SPECIFICATION 1. SCOPE. The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Office for direction. 2. APPLICATION. Recommended Usage included in the description of individual finishes are intended for information only. 3. DESIGNATION. The finish required on a standard or utility part is designated by adding the appropriate Finish Code to the Part Number as a suffix when a part is released. FINISH CODES SHALL NOT BE INCLUDED IN THE PART NUMBER BLOCK ON A UTILITY PART DRAWING. The Finish Code is obtained from Clause 6, DETAILED FINISH DESCRIPTIONS AND REQUIREMENTS. The Finish Code consists of letter S followed by a number and designation alpha codes (except SSW). The release for a standard or utility part is incomplete without the addition of a finish code to the Part Number. WORLDWIDE PART NUMBERS MUST BE RELEASED WITH A WORLDWIDE FINISH NUMBER. 3.1 DESIGNATION EXAMPLE. Part NumberW500001 – S437Finish Code S 437 M XA Standard/Utility part suffix designator Worldwide suffix number (300 or 400 series ) Process indicator (M = Mechanical or Non electrolytic) Subsequent treatment indicator NOTE: In the past, a number 1 after the S was used to indicate that