《ASME SA-240-2016压力容器用铬镍不锈钢板通用规范》.pdfVIP

2007 SECTION II, PART A SA-240/SA-240M SPECIFICATION FOR CHROMIUM AND CHROMIUM- NICKEL STAINLESS STEEL PLATE, SHEET, AND STRIP FOR PRESSURE VESSELS AND FOR GENERAL APPLICATIONS SA-240/SA-240M (Identical with ASTM Specification A 240/A 240M-04) 1. Scope 3. General Requirements 1.1 This specification covers chromium, chromium- 3.1 The following requirements for orders for material nickel, and chromium-manganese-nickel stainless steel furnished under this specification shall conform to the plate, sheet, and strip for pressure vessels and for general applicable requirements of the current edition of Specifica- applications. tion A 480/A 480M. 3.1.1 Definitions, 1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values 3.1.2 General requirements for delivery, stated in each system are not exact equivalents; therefore, 3.1.3 Ordering information, each system must be used independently of the other. Com- bining values from the two systems may result in noncon- 3.1.4 Process, formance with the specification. 3.1.5 Special tests, 1.3 This specification is expressed in both inch-pound 3.1.6 Heat treatment, and SI units. However, unless the order specifies the appli- 3.1.7 Dimensions and permissible variations, cable “M” specification designation (SI units), the material